Laminated glass not including bullet resistant or polycarbonate 4.
Tempered glass doors without stiles.
Sliding doors are exempt from this rule as are tempered glass doors without stiles whose bottom rail is tapered to 60 degrees.
And the exposed surface of the glass is less than 60.
Specialty glass such as insulated or coated glass products may require procedures not contained in this guide.
Type p door full top and bottom rails the type p door is a classic all glass door design.
Our stile door collection features architecturally correct panel door our stile door collection features architecturally correct panel door styles from 1 2 3 5 and 7 panel or glass configurations.
Type p doors with vertical stiles full top and bottom rails with full height stiles.
Considerations for exterior doors.
All aluminum storefront doors must have a 10 inch bottom rail.
The door rails can match in height or vary to create a specific aesthetic.
Panic hardware on balanced doors.
Both nfpa 101 and the ibc state that when panic hardware is used on balanced doors the panic hardware must be push pad touchpad style and the pad shall extend no more than one.
Lori april 29 2018 at 4 10 pm reply.
Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch 255 mm bottom smooth surface height requirement 3.
Consult stiles for specific glazing instructions for specialty glass products.
This door has tempered glass and the bottom rail is tapered 60 degrees at the top therefore the 4 height of the.
Sliding doors shall not be required to comply with 404 2 10.
Each door is built with genuine stile and rail construction.
Sliding doors are exempt from this rule as are tempered glass doors without stiles whose bottom rail is tapered to 60 degrees.
Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch 255 mm bottom smooth surface height requirement ben.
Tapered glass stops can be used on doors without a bottom rail or 10 inch kick plate.
Tempered glass must be used for all glass adjacent to stairs ramps and landings if the glass is located within 36 inches of a walking surface.
Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch 255 mm bottom smooth surface height requirement.